Hydraulic Leg Notes:[if equipped with hydraulic legs.]
1. Raise table before leveling the frame body[pool play is when the table is raised]... lift table end to actuate hydraulics to raise table.
2. After leveling the frame then level the slate. After setup is complete: Lift ends slightly to lower the table for dining. To raise to play pool then lift end to actuate hydraulics.
It's ok if both legs don't actuate at the same time. Lifting in the middle of either end will normally actuate both legs of that end at the same time. If one leg doesn't actuate... simply go to that leg and lift.
This video shows a quick overview of the assembly and details about tables equipped with the Neon Light option.
This video shows leveling the slate(without a leveling rod) and covering with felt.
You should not have to use shims to level the slate, watch the video and you will see that the adjusting rod should be all you need to do to level, if you feel that a small shim is needed after adjusting the rod, then that is ok too.
Video below shows 1-piece slate.... our tables are actually 3-piece slate
This video shows you how to install all our tables that are equipped with a leveling rod.